Fire Magic Echelon Insulating Liner User Manual
Echelon insulating liner instructions, Important information & technical data
1
INSTALLER:
Leave these instructions with consumer.
CONSUMER:
Retain for future reference.
IMPORTANT INFORMATION & TECHNICAL DATA
Read these instructions and the safety and installation portions of the grill instructions before liner installation.
The insulating liner kit includes the pre-assembled liner, two support hangers, and a heat shield. Liner
cutout dimensions are given in Table 1. A nominal
1
/
16
" gap around the back and sides of the liner is
recommended for ease of installation. A minimum of 5" from combustible material is required directly
below the top of the support hangers/Stud A, to allow for clearance of the heat shield (See Fig. 2-2). If
a complete combustible shelf is installed beneath the heatshield, it must contain two ventilation cutouts.
The cutouts must be located directly below the right hand and left hand ends of the heatshield. Reference
Table 2 for dimensions. If the countertop thickness exceeds 2", new screw holes must be made in the
support hangers.
Countertops and cabinet faces made of combustible material, such as wood, Formica, and Corian, can
extend up against the outside walls of the insulating liner and be joined by a bead of silicone sealer rated
for 400° or higher, as shown in Fig. 3-1. Never build over the insulating liner with combustible materials, as
this will interfere with the grill hanger.
The cabinet base must include 100 sq. in. of ventilation within 12" of the fl oor. Refer to the grill safety
precautions and installation instructions for additional propane gas venting requirements (if applicable).
Replacement parts may be obtained from your nearest Robert H. Peterson Co. dealer. For assistance in
locating a dealer, you may contact the factory at the address listed below.
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue, City of Industry, CA 91746
REV 8 - 1302051115
L-C2-240
ECHELON INSULATING
LINER INSTRUCTIONS
Grill
series
Liner
Model
Height
Width
Depth
E660i
3176-50
12"
36
3
/
8
"
26"
E790i
3186-50
12"
42
1
/
8
"
26"
E1060i
3185-50
12"
55"
26"
Table 1 - Enclosure cutout dimensions (for liner)
Grill series
Width
Depth
E660i
4
1
/
4
"
16
3
/
4
"
E790i
4
1
/
4
"
16
3
/
4
"
E1060i
4
1
/
4
"
16
3
/
4
"
Table 2 - Combustible shelf cutout dimensions