Assembly (cont.), Operation – Fire Magic 2D-SSA Beverage Center User Manual

Page 7

Advertising
background image

REV 6 - 1402170710

L-C2-274

7

ASSEMBLY (cont.)

INSTALL PAPER TOWEL HOLDER (STAND
ALONE ONLY)

Unpack the paper-towel holder hanger, squeeze the open
ends together slightly, and insert them into the mounting
bracket on the front right (Fig. 7-1). Next, release the hanger
so that the ends poke out through the holes in the top and
bottom of the mount.

OPERATION

(UN)LOCKING CASTERS (STAND ALONE ONLY)

To lock a caster press down on the side of the lever with the
word "OFF" stamped on it until it stops and the caster will
not turn. To unlock, press down on the side stamped "ON."

TURNING THE LIGHT ON AND OFF (IF
EQUIPPED)

Note: The beverage center must be plugged in to a 110V

AC power source.

Locate the button underneath the right side of the light
panel. Press the button to turn on and off the two halogen
lights underneath the rack.

USING MAGNETIC BOTTLE OPENER

A magnetic bottle opener is located on the right side drawer.
To use simply insert the top of the bottle as shown in Fig.
7-4 and pull the bottom of the bottle downward until the cap
is removed. The cap will then stick to the magnet instead
of falling to the ground. Remove the cap from the magnet
and discard.

Fig. 7-1

Paper towel holder (stand alone only)

Fig. 7-2

Caster in locked position (stand alone only)

Fig. 7-3

Using the light switch

Fig. 7-4

Magnetic bottle opener (right drawer)

Advertising
This manual is related to the following products: