Fire Magic Accessory & Legacy Insulating Liner - Manual

1 L-C2-04309 REV 5 - 0912210954
Deluxe / Power Burner / Searing Station
Built-in Insulating Liners for Combustible
Enclosures
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
A rigid 1 /
2
" or 3 /
4
" black steel pipe should be used to conduct
the gas supply into the enclosure for connection to the outdoor
gas appliance. On units with a sheet metal bottom, a 1
3 /
8
"
diameter hole set in 4" from the left side and 5" from the rear
is provided for plumbing the gas connection (see Fig. 1-2).
Use a CSA approved stainless steel fl ex connector to link the
appliance to the gas line.
Never use a rubber hose to connect to the gas supply.
For pipe connections, use joint compounds that are resistant
to all gasses on all male pipe fi ttings. Tighten each joint
securely. Do not use pipe joint compound on fl are fi ttings.
Check all connections for leaks prior to use with a half-soap-
half-water solution. Never use a fl ame to check for leaks.
Fig. 1-2 Top view
Top view of enclosure
and insulating liner
Heat shield front
Stainless fl ex
connector
through here
1 3 /
8
" Diameter. (min.)
4"
5"
GAS REQUIREMENTS
Read these instructions and the safety and
installation portions of the product instructions
before beginning insulating liner installation.
Counter tops and cabinet faces made of
combustible material, such as wood, Formica,
and Corian, can extend up against the outside
walls of the insulating liner and be joined by a
bead of silicone sealer rated for 400° or higher,
as shown in Fig. 1-1. Never build over the
insulating liner with combustible materials, as
this will interfere with the grill hanger.
Enclosures built of wood or other combustible
materials must include the proper space for the
insulating liner. A support shelf or ledge below the
counter top is not needed to support the appliance
and insulating liner. The two support hangers
provided will support the liner and grill.
IMPORTANT INFORMATION
Fig. 1-1
Outside panel wall
Counter top & top of side panel
should be at the same level
Silicone bead
Insulating liner
Inside panel wall
Cut-out for gas
connector