Flowserve WG Series Limitorque User Manual
Page 17
17
Limitorque WG Series Worm Gear Operator FCD LMENIM2101-02 – 1/15
flowserve.com
11. Place the upper Thrust Washer (pc# 9) on the Worm Gear/Drive Sleeve (pc# 5).
12. Replace the O-Rings (pc# 20) in the Housing Cover (pc# 2).
Note: Lubricate the O-Rings before installation.
13. Install the Housing Cover (pc# 2) with the Cover Gasket (pc# 21).
14. Insert the Splined Adapter (pc# 4) into the Worm Gear/Drive Sleeve (pc# 5).
15. Install the Splined Adapter Retaining Ring (pc# 10).
16. Install the Pointer Cap (pc# 8), Gasket (pc# 31) and Drive Sleeve O-Ring
1
(pc# 18).
1
O-Ring (pc# 18) applies to WG-04 through -07 only. (Pc# 20), quantity of 2, applies to WG-75 through WG-12.
2
Ball Bearing (pc# 26) applies to WG-55 thru -12 only.
14 29
13
28
6
22
11
26
24
1
23
16
15
3
27
26 11
22 19
7
13 28
4
17
17
9
5
9
20
18
21
2
12
30
25
24
8
31
10
(QTY VARIES)
(QTY VARIES)
(VARIES)
(VARIES)
(VARIES)
1
PC-7 IS REPLACED BY
OPTIONAL SPUR GEAR
ATTACHMENT, IF SUPPLIED
Figure 4.8 – WG-04 through WG-12 Exploded View