Wiring, Worcester controls – Flowserve 90 Series Feedback Potentiometer User Manual
Page 2
2
Feedback Potentiometer and 4-20 mA Position Indicator for Series 90 Modular Accessory System
WCAIM2042
2.WIRING
Note: All wiring is to be run smoothly and neatly and away from any
rotating parts, using wire ties if necessary. Use caution to avoid
pinching wires and/or solenoid rectifiers between the base and
cover flanges.
a. For non-positioner/controller units only, add the second terminal
strip in the “secondary” location using the four #4 x
C\," self-
tapping screws provided. It is possible that a second terminal
strip is already present and available for use.
b. Connect the wires to the end terminal strip as shown.
Note: Wiring should be inserted only to mid-point of terminal
strip.
c. For any “P” or “D” option, go to section 3, CALIBRATION.
For any “4” option, go to section 4, CALIBRATION.
Flow Control Division
Worcester Controls
NON-POSITIONER/CONTROLLER
POSITIONER
CONTROLLER