Flowserve MK25/2 - Manual (Page 14)

14
1. Take heed of note “Danger” on page 8.
2. Undo hexagon-head bolts
A and remove cover B from trap body H .
3. Completely unscrew regulator R .
4. Remove strainer G .
5. Remove old gasket F .
6. Clean body, internals and all gasket surfaces.
7. Apply heat-resistant lubricant to all threads and the seating surfaces of the nozzle
seat and the cover (use for instance WINIX ® 2150).
8. Insert new gasket F .
9. Install strainer G .
10. Screw in regulator R and tighten with a torque of 140 Nm.
11. Put cover B onto the body H . Tighten hexagon-head bolts A alternately and in
several steps to a torque of 45 Nm.
1. Take heed of the note “Danger” on page 8.
2. Undo hexagon-head bolts
A and remove cover B from trap body H .
3. Remove capsule holder C .
4. Remove capsule D and clean it. Unscrew nozzle seat E .
5. Remove old gasket F and strainer G .
6. Replace capsule D in case of visible signs of wear or damage.
7. Clean body, internals and all gasket surfaces.
8. Apply heat-resistant lubricant to all threads and seating surfaces of the nozzle seat
and the cover (use for instance WINIX ® 2150).
9. Install strainer G , screw in nozzle seat E and tighten with a torque of 140 Nm.
10. Position capsule D onto the nozzle seat E and press evenly, such that the capsule
snaps into place.
11. Insert new gasket F .
12. Put cover B onto the body H . Tighten hexagon-head bolts A alternately and in
several steps to a torque of 45 Nm.
Clean/exchange capsule and nozzle seat
Maintenance
GESTRA steam traps MK 25... do not require any special maintenance. However, if
used in new installations which have not been rinsed it may be necessary to check
and clean the regulator (nozzle seat, capsule and capsule holder) and the strainer.
You can check steam traps MK 25... for steam loss during operation by using the
ultrasonic measuring unit VAPOPHONE
® or the test unit TRAP test ® .
Should you detect any loss of live steam clean the trap and/or replace regulator.
Check steam trap
■ Spanner A. F.18 mm to DIN 3113, form B
■ Spanner A. F. 36 mm to DIN 3113, form B
■ Torque spanner 20 – 140 Nm to DIN ISO 6789
Clean/exchange strainer
Tools
WINIX ® 2150 is a registered trademark of WINIX GmbH, Norderstedt