Installation – Flowserve TRS 5-6 User Manual
Page 10
10
Tools
■
Screwdriver (5.5/100)
Installation
TRS 5-6 b
On supporting rail (with mounting clip)
1. Clip temperature switch onto supporting rail.
2. Loosen cover screws and unplug cover from its base .
3. Select cable entry and remove corresponding seal.
On mounting panel
1. Loosen cover screws and unplug cover from its base .
2. Unscrew mounting clip .
3. Drill the hole marked in the base to 4.3 mm dia.
4. Fasten base with two M4 screws onto mounting panel.
TRS 5-6 c
1. Mount plastic card guide rail into 19" magazine.
2. Install screw-type connector.
3. Introduce 19" slide-in unit into magazine and fix with screws .
TRS 5-6 d
1. Mount plastic card guide rail into 19" magazine.
2. Install screw-type connector.
3. Introduce 19" slide-in unit into magazine and fix with screws .
E
A
D
C
A
E
D
F
B
G
G