Annex, Switching controller level electrode – Flowserve NRS 1-42 User Manual
Page 23
Advertising
23
Annex
Danger
The terminal strip of the NRS 1-42 is live during operation.
This presents the danger of electric shock.
Cut off power supply before mounting or removing the equipment.
Factory set default values of node IDs
The individual node IDs must be manually adjusted on the equipment.
Please observe the installation instructions of the device in question.
Switching
controller
Level electrode
Fig. 7
Attention
■
Do not assign the same node ID twice within the CAN bus network.
Assigning / changing node ID
If several systems of the same kind are to communicate in one CAN bus network, be
sure to assign one node ID for each individual system component (e. g. controller).
Detach terminal strips in order to change the code switch settings .
A
8
Advertising