Foxconn NF3GK8MA-RS - Manual (Page 63)

Chapter 5 NVIDIA RAID Introduction
• Assigning the Disks
The disks that you enabled from the RAID Config BIOS setup page appear in the
Free Disks block. These are the drives that are available for use as RAID array.
To designate a free disk to be used as a RAID array:
1. Tab to the Free Disks section. The first disk in the list is selected.
2. Move it from the Free Disks block to the Array Disks block by pressing the right
arrow key ( ). The first disk in the list is moved, and the next disk in the list is
selected and ready to be moved.
3. Continue pressing the right-arrow key ( ) until all the disks that you want to use
as RAID array appear in the Array Disks block.
Completing the RAID BIOS Setup
1. After assigning your RAID array mode, press F7. The Clear disk data windows
prompt appears.
It shows that two disks have been assigned as RAID1 array disks in the figure
above.
ＮＦ３ＵＫ８ＭＡ－ＮＦ３ＧＫ８ＭＡ－ｍａｎｕａｌ－Ｖ１．１．ｐ６５ 2005-3-16, 17:34 55