Foxconn Bloodrage - Manual (Page 40)

33
3
Advanced BIos features
► Removable Device Priority
This option is used to select the Priority for removable device.
► Hard Disk Boot Priority
This option is used to select the Priority for HDD startup. After pressing <Enter>, you can
select the HDD using the Up/Down arrow keys, and change the HDD priority using <PageUp>/
<PageDown>; you can exit this menu by pressing <Esc>.
► First/Second/Third Boot Device
These three options allow you to select the priority of boot sequence from different devices.
► Boot Other Device
With this function set to enable, the system will boot from some other devices provided that the
first/second/third boot devices failed.
► Boot Up Floppy Seek
This item controls whether the BIOS will be checking for a floppy drive while booting up. If it
cannot detect one (either due to improper configuration or physical unavailability), it will appear
an error message. Disabling this function, then POST will not detect the floppy.
► Boot Up NumLock Status
This item defines if the keyboard Num Lock key is active when your system is started. The
available settings are: On (default) and Off.
► Gate A20 Option
This feature determines how Gate A20 is used to address memory above 1MB. When this
option is set to Fast, the motherboard chipset controls the operation of Gate A20. But when
set to Normal, a pin in the keyboard controller controls Gate A20. Setting Gate A20 to Fast
improves memory access speed and thus, overall system speed, especially with OS/2 and
Windows. This is because OS/2 and Windows enter and leave protected mode via the BIOS
a lot so Gate A20 needs to switch often from enabled to disabled and back again. Setting this
feature to Fast improves memory access performance above 1MB because the chipset is
much faster in switching Gate A20 than the keyboard controller. It is recommended that you
set it to Fast for faster memory accesses.
Phoenix - AwardBIOS CMOS Setup Utility
Advanced BIOS Features
► Removable Device Priority Press Enter Item Help
► Hard Disk Boot Priority Press Enter
First Boot Device Hard Disk Menu Level ►
Second Boot Device CD-ROM
Third Boot Device Removble Select Removable Boot
Boot Other Device Enabled Device Priority
Boot Up NumLock Status On
Gate A20 Option Fast
Security Option Setup
APIC Mode Enabled
MPS Version Control for OS 1.4
OS Select for DRAM > 64MB Non-OS2
Report No FDD For WIN 95 No
Delay For HDD (Secs) 0
Full Screen Logo Show Enabled
Quantum Logo Show Enabled
Summary Screen Show Disabled
Debug Code Control LPC
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
Press Enter