Foxconn 865A01-PE-6EKRS - Manual (Page 62)

54
Chapter 3 BIOS Description
865A01 G/PE User Manual
IDE Primary Master/Slave UDMA (Default: Auto)
This option is used to set whether the IDE Primary Master/Slave Unit supports
Ultra DMA. With it set to Auto, BIOS will automatically test whether IDE sup
ports Ultra DMA; with it set to Disabled, the Ultra DMA function will be locked.
On-Chip Secondary PCI IDE (Default: Enabled)
This option is used to set whether the On-chip Secondary PCI IDE is used. The
available setting values are: Disabled and Enabled.
IDE Secondary Master/Slave PIO (Default: Auto)
This option is used to set the PIO transfer mode under the IDE Secondary Master/
Slave Controller. With it set to Auto, BIOS will automatically detect whether IDE
supports the Ultra DMA; with it set to Disabled, the Ultra DMA function will be
locked.
IDE Secondary Master/Slave UDMA (Default: Auto)
This option is used to set whether the second group of primary/secondary
equipment supports Ultra DMA. If the setting is Auto, BIOS will automatically
detect whether the IDE hard disk supports Ultra DMA; if the setting is Disabled,
it will be locked
SATA Mode(Default: IDE)
This option is used to set the SATA mode. When it is set to IDE, the mode will
be IDE only. The available setting values are: IDE and RAID.
Note:If want to use Raid Function, On-Chip Serial ATA must be set Enhance
mode.
On-Chip Serial ATA (Default: Auto)
This option is used to set the On-chip Serial ATA function. When it is set to
Disabled, the function will be locked; when it is set to Auto, the BIOS will lock
the function; with it set to Combined Mode, four HDDs at most will be
supported; with it set to Enhanced Mode, six HDDs at most will be supported
(for those under Windows 2000 and WindowsXP only); with it set to S-ATA Only,
only the S-ATA HDD can be used.
Serial ATA Port 0/1 Mode (Default: Primary Master/Primary Slave)
This option is used to set the Serial ATA Port 0/1 Mode.With the mode set to
Primary Master/Slave, the Primary IDE cannot be used; only the secondary
IDE and SATA ports 0/1 will be available. With the mode set to Secondary
Master/Slave, the secondary IDE will be unavailable; only the primary IDE and
SATA ports 0/1 can be used. With the mode set to Primary/Secondary Master,
and the option SATA Only selected, the SATA HDD acts as both the primary and
secondary drive. With the mode set to SATA 0/1 Master and the option SATA
Enhanced Mode selected, both IDE ports and both SATA ports will be available.
865A01-FOXCONN-V1.3-EN-121603.p65 2004-5-27, 18:02 54