Integrated peripherals, Onchip ata devices – Foxconn ELA User Manual
Page 35
3
28
Integrated Peripherals
► OnChip ATA Devices/OnBoard Devices/SuperIO Configuration/USB Configuration
Press <Enter> to go to relative submenu.
OnChip ATA Devices
► SATA#1 Configuration
SATA#1 are the SATA ports 1, 2, 3, 4 of the motherboard. This item allows you select the
mode of the SATA ports. Setting values are: [Disabled], [Compatible], [Enhanced].
► Configure SATA#1 as
This item is used to set the operation mode of your SATA ports 1, 2, 3, 4. Setting values are:
[IDE]; [RAID]; [AHCI].
[IDE] - This configures the SATA ports to support IDE mode.
[RAID] - When you enable RAID, it means all your SATA drives must also support AHCI.
[AHCI] - The Advanced Host Controller Interface (AHCI) specification describes the register
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Integrated Peripherals
► OnChip ATA Devices
[Press Enter]
Help Item
► OnBoard Devices
[Press Enter]
► SuperIO Configuration
[Press Enter]
OnChip ATA Devices
► USB Configuration
[Press Enter]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Press Enter]
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
OnChip ATA Devices
SATA#1 Configuration
[Compatible]
Help Item
Configure SATA#1 as
[IDE]
SATA#2 Configuration
[Enhanced]
JMicron 36x ATA Controller
[IDE Mode]
I
Disabled
Compatible
Enhanced
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Compatible]
Options