Fusion MS-DA51600 - Manual (Page 2)

2
AMPLIFIER SPECIFICATIONS
Peak Power
(Watts)
1600
Frequency
Response
10Hz -50kHz
Dimensions
(mm)
300(l) x 210(w) x 50(h)
11-13/16 x 8-1/4 x 2”
Power Ratings
80W RMS x 4 +
250W RMS x 1 @ 4Ω 1% THD+N
130W RMS x 4 +
330W RMS x 1 @ 2Ω 1% THD+N
250W RMS x 2 @ 4Ω Bridged 1% THD+N +
250W RMS x 1 @ 4Ω 1% THD+N
INSTALLATION
GUIDELINES
1. Ensure the +12V lead is disconnected
from the battery before you connect any
new equipment.
2. Ensure the mounting location will not
interfere with the gas tank or electrical
wiring.
3. Ensure the Amplifier is securely fastened
to the vessel to prevent injury in the event
of an accident.
4. Ensure all wiring is protected to avoid
pinching or crushing which could result in
damage to the audio system.
5. Ensure the mounting location has
sufficient air flow around the amplifier. If
the amplifier is mounted in an enclosed
space a 3” fan with ducting should be
used to aid in air flow.
6. Do not mount any amplifier on a subwoofer
enclosure as extended exposure to
vibration may cause malfunction of the
amplifier.
7. Ensure you use the recommended gauge
wire/cable for all amplifier connections.
WIRING
Ensure the audio system is turned off before
making any connections to the amplifier,
speakers or source unit, failure to do so could
result in permanent damage to the audio
system.
When wiring the FUSION amplifier ensure
that the cable is protected from sharp objects
and always use rubber grommets when wiring
through metal panels.
Ensure all terminals and connections are
protected from the vessel chassis and from
each other as failure to do so could result in
permanent damage to the audio system.
+12V CONNECTION
FUSION amplifiers should be connected directly
to the +12V battery terminal with an inline
fuse or circuit breaker as close the battery as
possible.
GROUND CONNECTION
When grounding/earthing your amplifier ensure
that the location is a good source of ground.
Make sure the metal is clean of paint etc as a
poor earth could damage your audio system.
REMOTE TURN-ON
CONNECTION
This connection turns the amplifier on & should
be connected to the remote turn on wire from
the Head Unit. If one is not available a switched
12v source must be used.