Fusion SG-SL10SPW - Manual (Page 4)

the subwoofer or speakers. If running the subwoofer out of
phase gives a better perception that the bass is from the
speakers’ location, the out-of-phase wiring is correct for your
system.
You can run the subwoofer out of phase by temporarily
mounting it to the mounting surface by using only three of the
mounting screws. Depending on the outcome of the test, the
remaining screws can be fastened or the subwoofer can be
removed to correct the wiring polarity.
Additional Information
True-Marine ™ Products
True-Marine products are subjected to rigorous environmental
testing under harsh marine conditions to surpass industry
guidelines for marine products.
Any product that bears the True-Marine stamp of assurance has
been designed for simplicity of use and combines the most
advanced marine technologies to deliver an industry leading
entertainment experience. All True-Marine products are
supported by the Fusion 3-year worldwide limited consumer
warranty. You can be assured Fusion stands by its products and
takes pride in delivering True-Marine quality products for your
vessel.
Optional LED Voltage Regulator
You can use an LED voltage regulator (optional accessory SG-
VREGLED) to regulate the battery voltage supply to the LED
lights. You can use the voltage regulator if you notice the levels
of brightness changing when you are running your engine,
charging, or using battery power only. The voltage regulator can
power the LEDs on up to ten Signature Series speakers or
subwoofers; for example four pairs of speakers and two
subwoofers.
Registering Your Signature Series
Help us better support you by completing our online registration
today.
• Go to
www.fusionentertainment.com .
• Keep the original sales receipt, or a photocopy, in a safe
place.
Dimension Drawings
Side View
À
130 mm (5.12 in.)
Á
220 mm (8.66 in.)
A Sports model subwoofer is shown, but the dimensions are the
same for the Classic model.
Sports Model Front View
À
275 mm (10.83 in.)
Á
247 mm (9.72 in.)
Classic Model Back View
À
275 mm (10.83 in.)
Á
247 mm (9.72 in.)
Cleaning the Subwoofer
NOTICE
Do not use harsh or solvent-based cleaners on the subwoofer.
Using such cleaners may damage the product and void the
warranty.
When mounted correctly, this subwoofer is rated IP65 for
protection in the harsh marine environment from the front of the
subwoofer. The subwoofer is not designed to withstand high
pressure water spray, which may occur when you wash down
your vessel. Failure to carefully spray-clean the vessel may
damage the product and void the warranty.
1 Clean all salt water and salt residue from the grill with a damp
cloth soaked in fresh water.
2 Use a mild detergent to remove a heavy buildup of salt or
stains.
Troubleshooting
Before you contact your Fusion dealer or service center, you
should perform a few simple troubleshooting steps to help
diagnose the problem.
If the Fusion subwoofer has been installed by a professional
installation company, you should contact the company so the
technicians can assess the problem and advise you about
possible solutions.
There is no sound coming from the subwoofer
• Verify that all connections are connected correctly to the
proper terminals.
4