GAI-Tronics 773-001 Outdoor Jack Station (Page/Party) - Manual (Page 2)

Pub. 42004-204A
Model 773-001 Outdoor Jack Station Page: 2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-204a.doc
01/04
Installation
1. Remove the four screws located on the front of the jack station under the hinged door.
2. Remove the two screws securing the jack plate. Remove the jack plate.
3. Remove the conduit plugs on the top and bottom of the jack station.
4. Secure the jack station to the conduit, feeding the cable through the conduit hub.
5. Wire the jack station. Refer to Figure 2 for wiring details. In single-party systems, the orange (spare)
conductor wire is the only one not used. In multi-party systems, tape back the conductors for the party
lines not linked to the portable station.
6. Secure the jack plate using the two screws saved earlier.
7. Secure the jack cover using the two screws saved earlier.
8. Verify proper operation of the station by plugging in and using a portable station.
Figure 2. Model 773-001 Wiring Details
REPLACEMENT PARTS
Part No. Description
14021-001 Jack Cover