GAI-Tronics 234L(x)-xxx LITE Series Stanchions User Manual
Page 11
Pub. 42004-393B
Model 234L(x)-xxx LITE Series Stanchion
Page: 10 of 18
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-393b.doc
03/07
1. After attaching the pre-wired mounting plate to the wall, make connections for the light components
on the main stanchion body. For ease of connection, and to maintain shorter wire lengths, position
the main stanchion body on a cart or temporary stand as close to the mounting plate as possible.
2. Connect the LED locator light and courtesy light wires to the proper 12 V dc power cable leads from
the weatherproof box. Connect the activation beacon wires to the relay cable leads from the
weatherproof box. Refer to Figure 5 and Figure 6.
N
OTE
1: Final installation wiring is exceptionally important when the interior lighting kit is installed.
Wires must adequately bundled and anchored so as not to cast shadows on the main stanchion body. For
proper wire routing and cable tie anchoring refer to Figure 6.
N
OTE
2: Ensure that all wiring connections are securely twisted, capped with the supplied wire nuts, and
properly taped with electrical tape.
With the exception of connecting to a GAI-Tronics telephone output and customer-supplied incoming
power, all internal wiring connections should now be complete.
Figure 6. Installation Wiring Diagram