Generic mode – GAI-Tronics 10458-101 600-Ohm / RF Electronics Paging Module User Manual
Page 12
Pub. 42004-415B
Model 10458-10x 600-Ohm/RF Electronics Paging Module
Page 10 of 28
e:\standard ioms - current release\42004 instr. manuals\42004-415b.doc
03/15
6. Select the Configuration tab to display the Configuration screen where all the paging module’s
operation parameters are set.
7. Select the Operation Mode from the pull-down menu. The screen will change appearance based on
the selection made. Each selection is shown below.
Generic Mode
Volume Level
- Select the speaker output level using the slide bar. The valid range is 4 mW to 8 W in
doubling increments (4 mW, 8 mW, 16 mW, etc.).
Automatic Level Adjust
– This feature is not compatible with the 10458-10x series Paging Modules.
Always use the setting Disabled.
Volume Adjust Address
– enter the DTMF Address code to be used for making volume changes from
a remote touch-tone device. The address should be a code unique to this unit. This address code may
include digits 0–9 as well as the extended DTMF digits A, B, C, and D. It can contain up to eight digits.
By using one or more of the DTMF digits A, B, C, or D, broadcast access will be restricted to equipment
capable of generating these DTMF digits.