2 of 11, When replacing an existing pvc cord, use a heyco, Figure 1. handset outline diagram – GAI-Tronics 12514-004, 12514-005, 12514-006 Thermoplastic Elastomer Cord Kits User Manual
Page 2
Pub. 42003-026C
T
HERMOPLASTIC
E
LASTOMER
C
ORD
R
EPLACEMENT
K
IT
Page:
2 of 11
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-026c.doc
7/00
3. When replacing an existing PVC cord, use a Heyco
®
bushing tool or a needle nose pliers to squeeze the
notch on the front panel side of the strain relief bushing and pull out the bushing.
4. When replacing a thermoplastic elastomer cord, remove the handset cord fastener clip located on the
back side of the front panel. The fastener clip secures the bushing and the cord to the front panel.
5. Pull the old cord through the front panel and set aside.
6. Remove the lower cap from the handset. Lift out the transmitter and the transmitter cup. Disconnect
both wires.
7. Remove the receiver cap, lift out the receiver and disconnect both wires.
8. Pull the wire harness out of the handset.
YELLOW
BLUE
BLACK
WHITE
GREEN
RED
TRANSMITTER
CAP
WASHER
TRANSMITTER
RECEIVER
CAP
GASKET
RECEIVER
PLASTIC CUP
PRESSBAR
COPPER SPRING
COPPER PLUNGER
Figure 1. Handset Outline Diagram