GAI-Tronics 12526-001 Kit for 13340 Stainless Steel Bracket - Manual (Page 3)

Pub. 42003-098C
M ODEL 12526-001 M OUNTING B RACKET R EPLACEMENT K IT Page: 3 of 4
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-098c.doc
10/98
Installation of Model 13302 and 13304 Speaker Horns
Hardware used for Model 13302 and 13304 installation only. (Not shown in Figure 1.)
Qty. Description
1 Speaker mounting bracket, stainless steel
2 Carriage bolt, ½-13
×1.25-inch, stainless steel
2 Hex nut, ½-inch, stainless steel
2 Flat washer, ½-inch, stainless steel
2 Lock washer, split-ring, ½-inch, stainless steel
1. Disassemble and remove existing mounting bolts, split-ring lock washers, and flat washers from each
side of the horn. Remove the existing bracket. (New stainless steel hardware is included in this kit to
replace the existing bracket hardware, if needed.)
2. Align the new stainless steel mounting bracket over mounting holes on sides of horn.
3. Insert the hex bolts through the split ring lock washers, the ½-inch flat washers, and the mounting
bracket and into the threaded holes located each side of the horn.
4. Orient the horn to the desired position, and tighten the nuts to 180–200 in-lbs. torque.