GAI-Tronics RigCom Station PCBA Replacement Kit User Manual
Page 2
Pub. 42003-194A
R
IG
C
OM
S
TATION
PCBA
R
EPLACEMENT
K
IT
Page:
2 of 3
\\s_eng\gtcproddocs\standard ioms - current release\42003 kit manuals\42003-194a.doc
09/02
Instructions
1. Mount PCBA on existing standoffs using existing hardware.
2. Wire as shown in Figure 1 below.
Note: Relay K1 is NOT USED in the Master and Common Talk stations.
Model 12705-002
This kit is intended for the MS3987 Slave RigCom 120 V ac Station. It consists of the following
components:
Qty Description
1 WBA4201
PCBA
1 Relay
1 Clip
Instructions
1. Install relay on K1.
2. Secure using clip.
3. Mount PCBA on existing standoffs using existing hardware.
4. Wire as shown in Figure 1 below.
Model 12705-003
This kit is intended for the MS3988 Common Talk and F96019 Master RigCom 12 V dc Stations. It
consists of the following component:
Qty Description
1 WBA4202
PCBA
Instructions
1. Mount PCBA on existing standoffs using existing hardware.
2. Wire as shown in Figure 1 below.
Model 12705-004
This kit is intended for the MS3990 Slave RigCom 12 V dc Station. It consists of the following
components:
Qty Description
1 WBA4202
PCBA
1 Relay
1 Clip
Instructions
1. Install relay on K1.
2. Secure using clip.
3. Mount PCBA on existing standoffs using existing hardware.