Gladiator GAWG262DBG Starter Series Wall GearBox - Manual (Page 3)

3
INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed
Parts Supplied for Standard Mount
Parts Supplied for Cabinet
Cabinet Use Requirements
■ Intended for use in a garage.
■ Maximum weight limit is 40 lbs (18 kg) for each shelf.
■ Maximum weight limit is 150 lbs (68 kg) for the cabinet.
Unpack the Cabinet
1. Open the cabinet door.
NOTE: Locate the key, and unlock the door.
2. Remove and verify the contents. See “Parts Supplied” in “Tools
and Parts.”
3. Dispose of/recycle all packaging materials.
Install the Cabinet to the Wall
IMPORTANT: Decide whether you are going to mount the cabinet on
Gladiator
® GearWall ® panels or GearTrack ® channels, or on a
standard wall. Follow the instructions that apply to your installation.
Install Cabinet to a Standard Wall
NOTE: For track mounting, see “Accessories.”
IMPORTANT: The mounting holes in the top and bottom cabinet
back panels are spaced as shown to allow you to mount the wall
cabinet to your garage wall studs.
1.
Locate the wood studs in your garage wall.
2. Align 2 holes at the top and 2 holes at the bottom with the wood
studs, and mark the location of the holes.
3. While 2 or more people hold the cabinet against the wall, attach
the wall cabinet to the garage wall using
¹⁄₄" flat washers and
¹⁄₄"– 20 x 1¹⁄₂" lag screws.
4. Using a
⁷⁄₁₆" wrench, fully tighten the screws.
Standard Wall Mounting
Standard Wall Mounting Dimensions
■ Phillips screwdriver ■ ⁷⁄₁₆" wrench (standard
mount)
■ ¹⁄₄" – 20 x 1¹⁄₂" lag screws (4) ■ ¹⁄₄" flat washers (4)
■ Full-width shelves (1)
■ Gladiator brand badge (1)
■ Key (1)
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
16"
(40.64 cm)
22.9"
(58.27 cm)
24"
(60.96 cm)
16"
(40.64 cm)
22.9"
(58.27 cm)
24"
(60.96 cm)
24"
(60.96 cm)