Gladiator GACK04KDSX Ready-To-Assemble Modular GearBox Caster Kit - Manual (Page 3)

3
Assemble Cabinet
Gather the required tools before starting installation.
Tools Needed:
Tools Supplied:
IMPORTANT:
■ Two people may be required to complete the assembly.
■ As you assemble the cabinet, make sure the edges with the
holes are facing up.
■ If you are assembling the cabinet on the floor, fasten the eight
front corner bolts, two at each corner, after you stand the cabinet
upright.
1. Place side panel (P1) on a flat, firm surface so that the edge with
the holes is facing up as shown.
2. Insert the cabinet top (P2) between the edges of side panel (P1).
NOTE: Make sure the edges with the holes are facing up.
3. Align the holes and attach the top (P2) to side panel (P1) using
six hex-head bolts (F1) and two
⁵⁄₁₆" flange nuts (F2) as shown.
Do not tighten completely.
4. Position side panel (P3) so that the top (P2) is between the edges
of side panel (P3).
5. Align the holes and attach the top (P2) to the side (P3) using
six hex-head bolts (F1) and two
⁵⁄₁₆" flange nuts (F2) as shown.
Do not tighten completely.
6. Insert cabinet bottom (P4) between the edges of side panels
(P1 and P3).
NOTE: Make sure the edges with the holes are facing up and that
the threaded posts are standing up on the inside of the unit as
shown.
7. Align the holes and attach the bottom (P4) to the side panels
(P1 and P3) using six hex-head bolts (F1) and two
⁵⁄₁₆" flange
nuts (F2) for each side as shown. Do not tighten completely.
Attach Lower Back Panel
1. Using seven Phillips-head screws (F3c), attach the lower back
panel (P6) to the bottom (P4) and sides (P1 and P3) as shown.
Tighten screws completely.
2. Using the hex key (provided), completely tighten all the cabinet
bolts and nuts.
Install Leveling Legs
The Gladiator ® Modular GearBox is designed to be either stationary
or to roll on casters. To order the Gladiator ® Steel Modular GearBox
Caster Kit, see “Accessories.”
1.
Place the cabinet on its side.
2. Screw a leveling leg (P7) into each of the four rivet nuts located at
the corners of the cabinet as shown.
F1 F2
F1 ⁵⁄₁₆ " Hex-head bolt (24)
F2
⁵⁄₁₆
" Flange nut (8)
■
¹⁄₂" Wrench
■ ³⁄₈" Wrench
■ Phillips screwdriver
■ Level
■ Hex key ■ Key
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
F3c
F3c Phillips-head screw (7 - black)
P2
P1
P3
P4
P3
P2
P1
P4
P3
P2
P6