Gladiator GAWG28FDYG Full-Door Wall GearBox - Manual (Page 4)

4
6. Align the two holes in each corner. Using hex-head bolts (F1),
fasten the side panels (P1) to the bottom (P3) as shown. Do not
tighten completely.
Attach Back Panels
1. Align the seven tabs in the upper back panel (P4) with the loops
in the top (P2) and sides (P1) of the cabinet.
2. Slide the upper back panel (P4) toward the cabinet top (P2) until
the back panel is firmly in place.
NOTE: Make sure each tab is inserted fully behind the loop as
shown.
3. Align the four side tabs on lower back panel (P5) with the loops in
the cabinet sides.
4. Slide the lower back panel upward until the top of the lower
panel is under the upper back panel (P4).
NOTE: The upper back panel will slightly overlap the lower back
panel.
5. Using Phillips-head screws (F3c), fasten the upper back panel
(P4) to the lower back panel (P5) and the lower back panel to the
cabinet bottom (P3).
6. Completely tighten all back panel screws.
7. Starting with the front of the cabinet, using the hex key
(provided), completely tighten all the bolts.
Install Doors
The door hinges are designed with keyhole slots at the top and
bottom so the door will hang on the cabinet while you are fastening
the screws.
1.
Start Phillips-head screws (F3c) in both the top and bottom holes
on each side of the cabinet.
2. Hang the right-hand side door (P7) from the top and bottom
screws, and hand tighten.
3. Insert the middle two screws through the door hinge into the
cabinet and hand tighten.
4. Repeat steps 2 and 3 to attach the left-hand door (P8).
5. Align the doors and completely tighten the screws.
F3c
Phillips-head screw (5)
A. Holes to install mounting bracket
P1
P2
P3
P1
P1
P3
P3
P1
P4
P1
A
F3c
Phillips-head screw (8)
P4
P5
P1
P3
P7
P3
P1
P2
P4
P5