Grandstream GXP1100 User Manual - Manual (Page 40)

FIRMWARE VERSION 1.0.8.4 GXP1100/GXP1105 USER MANUAL Page 38 of 53
Enable Idle Mute
If this feature is enabled, MUTE key will take effect in idle state and future
incoming call will be answered with mute.
Disable Transfer Disables the Transfer function. The default setting is "No".
In-call dial number on pressing
transfer key
Configures the number for the phone to dial as DTMF during the call
using TRAN button.
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Do Not Escape # as %23 in
SIP URI
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Click-To-Dial Feature Enables Click-To-Dial feature. The default setting is "Disabled".
Blink message LED on ringing Message LED light will blink if there is an incoming call.
Call History Flash Writing:
Write Timeout
Defines the interval (in seconds) to save the call history to phone's flash.
The default value is 300 seconds.
Call History Flash Writing:
Max Unsaved Log
Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
Enable FLASH Key as CONF
If set to "Yes", the FLASH key can be used to establish 3-way
conference. The default setting is "No".
Settings -> Multicast Paging
Paging Barge
During active call if incoming multicast page is higher priority than this
value the call will be held and multicast page will be played. Note: 1 is the
highest value.
Paging Priority Active
If enabled, during a multicast page if another rmulticast is received with
higher priority, that one will be played instead. Note: 1 is the highest
value.
Multicast Paging Codec The codec for sending multicast pages.
Multicast Listening Defines multicast listening addresses and labels.
Settings -> Ring Tone
Call Progresses Tones:
System Ring Tone
Dial Tone
Second Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
Busy Tone
Reorder Tone
Configures ring or tone frequencies based on parameters from local
telecom. The default value is North American standard. Frequencies
should be configured with known values to avoid uncomfortable high
pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise