Grandstream HT502 User Manual - Manual (Page 42)

FIRMWARE VERSION 1.0.14.1 HT502 USER MANUAL Page 40 of 54
Tel URI The default setting is “Disabled”. If the phone has an assigned PSTN
Number, this field should be set to “User=Phone” then a
“User=Phone” parameter will be attached to the “From header” in the SIP
request to indicate the E.164 number. If server supports TEL URI format, then this
option needs to be selected.
SIP Registration Controls whether the HT502 needs to send REGISTER messages to the proxy server.
The default setting is Yes.
Unregister on Reboot Default is No. If set to Yes, the SIP user’s registration information will be cleared on
reboot.
Outgoing Call without
Registration
Default is No . If set to “Yes,” user can place outgoing calls even when not registered (if
allowed by Internet Telephone Service Provider) but is unable to receive incoming calls.
Register Expiration This parameter allows the user to specify the time frequency (in minutes) the HT502
refreshes its registration with the specified registrar. The default interval is 60 minutes
(or 1 hour). The maximum interval is 65535 minutes (about 45 days).
Reregister before
Expiration
This parameter allows the user to specify the reregisteration time before expiration.
Registration Retry Wait
Time
Retry registration if the process failed. Default is 30 seconds.
Local SIP port Defines the local SIP port the HT502 will listen and transmit. The default value for FXS
port 1 is 5060. The default value for FXS port 2 is 5062.
Local RTP port Defines the local RTP port pair the HT502 will listen and transmit. The default value for
FXS port 1 is 5004. The default value for FXS port 2 is 5012.
Use Random Port This parameter forces the random generation of both the local SIP and RTP ports when
set to Yes. This is usually necessary when multiple HT502 are behind the same NAT.
Hold Target Before
Refer
Default is Yes. Allows user to hold the phone call before refer it. If set to No, the call will
not be hold before referred.
Refer to Use Target
Contact
Default is NO. If set to YES, then for Attended Transfer, the “Refer-To” header uses the
transferred target’s Contact header information.
Transfer on Conference
Hang up
Default is No. In which case if the conference originator hangs up the conference will
be terminated. When option YES is chosen, originator will transfer other parties to
each other so that B and C can choose either to continue the conversation or
hang up.
Disable Bellcore Style
3-Way Conference
Default is No . you can make a Conference by pressing ‘Flash’ key. If set to Yes, you
need to dial *23 + second callee number.
Remove OBP from
Route Header
Default is No. When option YES is chosen, the Out Bound Proxy will be removed from
Route header.