Guntermann & Drunck USB 2.0 Ranger 2204 User Manual
Page 7
Installation Guide
Before you can install the Ranger 2204, you need to prepare your site:
1.
Determine where the computer is to be located and set up the computer.
2.
Determine where you want to locate the USB device(s).
3.
If you are using surface cabling, the Ranger 2204 supports a maximum distance of 100m.
OR
If you are using premise cabling, ensure Cat 5e cable is installed between the two locations,
with Cat 5e information outlets located near both the computer and the USB device(s) and
the total length, including patch cords is no more than 100m.
Installing the LEX Unit
1.
Place the LEX unit near the computer.
2.
Install the supplied USB cable between the LEX and USB port on the host computer.
Installing the REX Unit
1.
Place the REX unit near the USB device(s) in the desired remote location.
2.
Plug the power adapter into a suitable AC outlet.
3.
Connect the power adapter to the REX unit.
LEX
Computer
All USB 2.0 and 1.1 Devices
Up to 100m between extenders over Cat 5e cable (or better)
REX
6