Guralp Systems Scream - Manual (Page 123)

User guide
1. Choose File Setup… → to display the Setup window. Choose
Print.
This window only applies to continuous mode printing; for page
mode printing, you should use the standard File Printer
→
Setup… window.
2. Set Port to the name of the parallel port connected to the printer.
3. Set Resolution to a suitable value for the printer, in dots per inch
(DPI) or pins. Ensure that the mode you select is within the
capabilities of the printer, as Scream! cannot do this
automatically.
4. Set Print Width to the width of the printout, in inches (leaving
some room for binding, notes, etc., if desired) and Page Length
to a suitable value, also in inches. Page Length does not need to
correspond to an actual page size; it is only used to specify
when to print certain labels (see below).
5. The final three options determine when to print various labels,
namely: the Stream ID of each stream, an amplitude scale, and a
date-stamp.
If you select Every Page for one of these, the label will be printed
at intervals of Page Length, above.
January 2014 123