Harken 1807, 1807HL System A Battcars: built before 2005 User Manual
Page 10
10
Loading Cars On Track
13
Slide cars onto the
track beginning
with the two headboard
cars (1792 headboard
cars have lug in the cen-
ter).
Slide Battcars onto the
track so that the housing
for the vertical shaft is at
the top of the car.
If the mast is up, use a
halyard to hold the cars.
Tip: Hold car loader
against the track firmly
until the car is com-
pletely on the upper
tracks.
14
Slip the connector
slug into the mast
groove and install this on
the bottom full length
track piece.
Slip the remaining three
or four mounting slugs
and end stop slug in
place and tape them
if necessary.
15
Install bottom track
and lower end stop
using blue Loctite on
screws. Securely tighten
all screws.
Mast
Track
End stop
Screws
Note: End stop screws
must go through track
or stop is not effective.
16
Ease cars onto
bottom section.
17
1792: Install the
headboard coupler
so that the cotter pin end
of the clevis pin is toward
the middle of the coupler.
1807: Coupler will be
pre-assembled. Ignore
this step.