Harken 2700 Traveler - Manual

Terms
Installing Traveler Car on Track
Position car at end of track and gently roll car on. Car should roll on easily. If not, check to make
sure you are using CB track. Do not remove ball retaining wires. Cars will not roll unless they
have retaining clips. Exception: CB+ cars can convert to non-CB cars. See third page.
Car Car width Track
Micro 1 9 /
16
" (40 mm) 2707, 2709
Small Boat 2 1 /
4
" (57 mm) 373, 374, 2720, 2721, 2725, 2751
373/2720/2751
374/2725 2721
2707
Note: Track not shown actual size.
2709
N15W24983 Bluemound Rd., Pewaukee, WI 53072-4974 USA
Telephone: (262) 691-3320 • Fax: (262) 701-5780
Web: http://www.harken.com • Email: [email protected]
INSTALLATION SHEET
CB Traveler Cars
Micro: 2700, 2701, 2702, 2703
Small Boat: 382, 2726, 2727, 2728, 2729, 2730, 2731, 2732,
2733, 2734, 2735, 2736, 2737, 2738, 2753, 2754, 2756, 2757
Accessories: Control Tangs
Mircro: 2705; Small Boat: 2749
Track Compatability
CB – Captive bearings. Wire retaining clips hold bearings
captive for easy loading onto track and for maintenance.
CB+ cars – CB cars that can convert to old style non-CB track.
Corner keepers – Used on CB+ cars to help retain balls
when cars are off track. Introduced beginning of 2015.
Retaining clips – Formed wires for holding bearings.
CB style track – Track designed with deeper grooves
to accept CB car retaining clips.
Micro
13 mm ( 1 /
2
")
Small Boat
22 mm ( 7 /
8
")
CB cars are shipped for use on CB track with grooves at waist to accept retaining clips. Track was
first supplied by Harken in 2002. See end of manual if you have older track.
CB+ Car Underside
Corner
keeper
Retaining
clip
+ stamp
at one end