Harken 46.2PT Winche - Manual (Page 13)

13 Radial Winch 46.2 PT Installation and Maintenance Manual
Assembly
Make sure that the holes and drainage channels in the base of the winch are not obstructed
Assemble the winch in the reverse order of the sequence in the section on disassembly.
To tighten bolts, use the torque indicated in the disassembly procedure.
To assemble the pawls:
correctly position the spring in its housing as
shown at left. Hold the spring closed and slide
the pawl into its housing. Once in position,
check that the pawls can be easily opened and
closed with a finger.
In case of doubt concerning the assembly procedure contact Harken ® Tech Service: [email protected]
Harken ® limited worldwide warranty
Refer to the Harken ® Limited Worldwide Warranty in the Harken ® Catalogue and on the website
www.harken.com
Ordering spare parts
Spare parts can be requested from Harken ® as
described in the Harken ® Limited Worldwide
Warranty, indicating the part number in the
Parts List and including the serial number of
the winch for which the parts are required.
The serial number of the winch is printed on
a plate on the drum support of the winch.
OIL
Harken ® limited worldwide warranty - Ordering spare parts
W XXXXX
XXXXXXXXX