Harken 80.3ST Winche - Manual (Page 12)

12 Radial Winch 80.3 ST Installation and Maintenance Manual
27. Remove the washer n°26
Important: The plastic washer must be posi-
tioned in contact with the winch base.
If it is necessary to replace any jaws of the winch, proceed as follows:
Once the winch is completely disassembled, clean the parts: use a basin of diesel oil to soak
metal components and rinse plastic parts in fresh water. Once you have done this, dry the parts
with cloths that do not leave residue.
Inspect gears, bearings, pins and pawls for any signs of wear or corrosion.
Carefully check the teeth of gears and ring gears to make sure there are no traces of wear.
Check the roller bearings and check there are no breaks in the bearing cages. Replace worn or
damaged components.
Carry out maintenance on components using the products listed below. For more information on
which products to use where, refer to the exploded diagram below.
Use a brush to lightly lubricate all gears, gear pins, teeth and all moving parts with grease. Lightly
lubricate the pawls and springs with oil. Do not use grease on the pawls!
I. Unscrew the 3 screws n°46
( 4Nm/35 in-lb) II. Remove the jaws