HB Optoelectronic HBB056 - Manual (Page 7)

HBB056 User Guide
5
Connection
The battery is fully charged and ready to use when you receive the battery. (To extend the useful life of the Battery, before you
recharge it the first time, run the Pico Projector to a complete discharge of the battery, then recharge it completely.) Follow the steps
below to connect the battery to the projector.
1. Place the projector above the battery and make sure the screw on the battery is in line with the screw hole on the back of the
projector.
Note: To facilitate the positioning of the
screw, fit the extended area of the
screw hole into the gap on the ring
around the screw.