Highgear VIA - Manual (Page 10)

en
gl
is
h
16
en
gli
sh
17
VIA BASIC & VIA PULSE:
1. Remove battery door using a coin or other small
object.
2. Remove old batteries.
3. Install new batteries, making sure the polarity
of each is correct.
4. Replace and tighten the battery door.
5. Replace the battery compartment and fasten
the screw.
NOTE: The VIA units are powered by CR2032
3v Lithium batteries. These batteries are very
common and can be found at most drug stores
and camera shops.
CHANGING THE BATTERIES CHANGING THE BATTERIES
VIA FM & VIA PANICALARM:
1. Flip open the clip and remove the battery door
by unscrewing the secured screw.
2. Remove old batteries.
3. Replace batteries with new CR2032 x 1(3V)
and CR1130 x 1(3V) batteries, making sure the
polarity of each is correct.
4. Replace and tighten the battery door.
NOTE: The VIA units are powered by CR2032
3v Lithium batteries. These batteries are very
common and can be found at most drug stores
and camera shops.