Hoefer TE42 - Manual (Page 19)

•
p11
After the transfer is complete
1
Turn the voltage and current settings to zero and turn
off the power supply. Disconnect the leads from the
power supply jacks.
2
Lift off the lid. Use the plastic hook (stored in the
holder at the side of the unit) to lift up a cassette
just far enough to be able to grab it and place it
into a tray.
3
Open each cassette carefully and remove the gels and
membranes. Label each membrane and indicate the
sample side. Lift membrane(s) with blunt forceps and
air dry, or follow the instructions of your protocol.
4
Discard the blotting paper, but reuse the sponges.
5
Rinse the unit immediately after use. (See the Care and
maintenance section on the next page.)
Note: It is a good idea to stain the
gel to determine the completeness
of the transfer.
Note: Do not store used buffer
with transfer tank. Chill buffer to
10 °C before reuse.