Dometic 3200 Series - Manual (Page 7)

7
Clean your SeaLand toilet regularly for maximum sanitation and operational ef-
ficiency. You can clean it just as you would a household toilet. do not use caustic
chemicals, such as drain-opening types, as they will damage the seals.
boWL cLeANING: For stubborn stains, use SeaLand Toilet Bowl Cleaner
(fig. A). It’s manufactured especially for use with SeaLand ceramic toilets. In
certain locations where water is hard, a build-up of lime may dull the toilet bowl
finish. Restore the shine with this cleaner. If you cannot find our brand in your
area, contact SeaLand Product Customer Service for your nearest dealer. If it
is not available, you can also use most non-abrasive bathroom and toilet bowl
cleaners (Bar Keeper's Friend ® spray cleaner, Clorox ® toilet bowl cleaner, Sani-
Flush ® toilet bowl cleaner, etc.). Please follow label instructions.
SeAL cLeANING: After an extended time, mineral deposits from hard water
can build up under the edge of the rubber bowl seal, resulting in a slow leakdown
of water from the bowl. To prevent this mineral build-up, periodically clean under
the bowl seal with SeaLand Toilet Bowl Cleaner (fig. B).
. Shut off water supply.
2. Apply cleaner onto a cleaning tool (soft-bristle brush, etc.), open the flush
ball by pressing on flush lever, and scrub under the seal. Make sure to push
bristles between bottom of seal and top of flush ball surface to scrub all parts
of seal that come into contact with flush ball.
3. Close ball and wait 2-3 minutes.
4. Open flush ball. Use brush and water to rinse away cleanser and loosened
deposits.
PRoPeR cLeANING ANd MAINTeNANce
At the end of each traveling season, the SeaLand toilet should be winterized for storage by using potable water-
safe antifreeze in the system.
To use antifreeze:
. Empty the blackwater tank.
2. Thoroughly flush system with fresh water.
3. Empty freshwater tank and blackwater tank.
4. Add freshwater antifreeze to freshwater tank.
5. Flush freshwater antifreeze through toilet and into the blackwater tank. Each installation is different, so amounts
may vary. User discretion is required to assure adequate protection.
6. Turn off electrical power.
NoTe: Use nontoxic antifreeze designated for potable water systems. (See vehicle owner’s manual.)
cAuTIoN: Never use automotive-type antifreeze in freshwater systems.
WINTeRIzING
Water Valve
Vacuum Breaker Assembly
SPARe PARTS
The following spare parts should be kept available at all times:
Flush Ball Seal
Flush Ball
description Part Number Quantity
see parts list
see parts list 

description Part Number Quantity
see parts list
see parts list 

fig. b
To avoid damaging the Teflon ® -coated seal, do NoT uSe:
– abrasives (Comet ® , Soft Scrub ® cleansers etc.)
– caustic chemicals (Drano ® clog remover, etc.)
– lubricants and cleaners containing alcohols or
petroleum distillates
(Pam ® cooking spray, Pine-Sol ® cleaner, Wd-40 ®
lubricant, etc.).
fig. A
® Bar Keepers Friend is a registered trademark of SerVaas
Laboratories Inc.
® Clorox, Pine-Sol and Soft Scrub are registered trademarks of
The Clorox Co.
® Comet is a registered trademark of Prestige Brands International.
® Drano is a registered trademark of S.C. Johnson & Son Inc.
® Pam is a registered trademark of ConAgra Foods.
® Sani-Flush is a registered trademark of Reckitt Benckiser Inc.
® Teflon is a registered trademark of DuPont Co.
® WD-40 is a registered trademark of WD-40 Company.