Hyundai 2006 Santa Fe User Manual

Page 220

Advertising
background image

6

DO-IT-YOURSELF MAINTENANCE

7

!

The engine oil and filter should be changed at
those intervals specified in the maintenance
schedule in Section 5. If the car is being driven
in severe conditions, more frequent oil and filter
changes are required.

The procedure for changing the oil and filter is
as follows:

1. Park the car on level ground and set the

parking brake. Start the engine and let it
warm up until the needle on the coolant
temperature gauge moves above the lowest
mark. Turn the engine off and place the gear
selector lever in "P" (automatic) or reverse
gear (manual transaxle).

2. Open the hood and remove the engine oil

filler cap.

3. Slide underneath the car and loosen the

drain plug by turning it counterclockwise with
a wrench of the proper size. Be sure that a
drain pan is in position to catch the oil as it
drains out, then remove the drain plug.

WARNING:

Be very careful when draining the engine oil
as it may be hot enough to burn you!

4. When the oil has stopped draining, replace

the drain plug using a new gasket and re-
tighten by turning it clockwise.

Oil pan drain plug tightening torque:
3.5 ~ 4.5 kgf.m

5. Remove the oil filter by turning it counter-

clockwise with a oil filter wrench of the proper
size. A certain amount of oil will come out
when you remove the filter. So be sure to
have your drain pan in place underneath it.

6. Install a new oil filter in accordance with the

instructions on the carton or on the filter itself.
Do not over-tighten. (Tightening torque :
1.2 ~ 1.6 kgf.m)
Be sure that the mounting
surface on the engine is clean and that the
old gasket is removed completely. Lubricate
the new gasket on the filter with clean engine
oil before installation.

7. Remove the engine oil level dipstick.
8. Refill the crankcase with the recommended

engine oil. Refer to the specification in chap-
ter 9 for engine oil capacity.

!

CAUTION:

Slowly pour the recommended oil using by
a funnel. Do not overfill! Engine damage
may occur if overfilled.

9. Start the engine and check to be sure no oil

is leaking from the drain plug or oil filter.

10.Shut off the engine and recheck the oil level.

NOTE:

Always dispose of used engine oil in an
environmentally acceptable manner. It is
suggested that it be placed in a sealed
container and taken to a service station for
reclamation. Do not pour the oil on the
ground or put it in with the household
trash.

Advertising