Dremel 6300 - Manual (Page 13)

-13-
Material Application Grit Size
All wooden materials (e.g.,
hardwood, softwood, chipboard,
building board) Metal materials–
Metal materials, fiberglass
and plastics
Paint, varnish, filling compound
and filler
Masonry, stone, cement
and thin set
Selecting Sanding/Grinding Sheets
GRINDING
The diamond paper accessory
allows for the Multi-Max to be used
for grinding away cement, plaster or
thin set. Preparing the surface for tile
replacement is a common application for this
accessory.
The diamond paper needs to be mounted to
the backing pad prior to use.
Select a low to high speed depending on the
material removal rate desired.
Corners may be finished using the tip or edge
of the selected accessory, which should
occasionally be rotated during use to distribute
the wear on the accessory and backing pad
surface.
Grind with a continuous motion and light
pressure. DO NOT apply excessive pressure -
let the tool do the work. Excessive pressure
will result in poor handling, vibration, and
premature wear on the diamond paper sheet.
For coarse-sanding, e.g. of
rough, unplanned beams and
boards
For face sanding and planing
small irregularities
For finish and fine sanding of
wood
For sanding off paint
For sanding primer (e.g., for
removing brush dashes, drops
of paint and paint run)
For final sanding of primers
before coating
For smoothing, shaping and
braking edges
Coarse
Medium
Fine
Coarse
Medium
Fine
Coarse
60
120
240
80
120
240
60
Sand Paper (Dark)
Sand Paper (White)
Diamond Paper
DM 2610958399 07-08.qxp 8/6/08 2:15 PM Page 13