IBEA IBT-500 Series - Manual (Page 32)

Pag. 32 Minitransporter IBT-500R / H / DH/ DHZ
PRECAUTIONS IN COLD WEATHER
STORAGE
After each use in the winter, be sure to remove the mud and the other foreign substances adhering to the
body, as such substances, if they freeze, can cause breakdowns and other problems. Then park the unit
on concrete or on hard, dry ground. (In extremely cold regions, it is effective to lay railroad ties, etc.
under the crawlers, at a right angle to the body).
Moreover, if parts of the unit freeze, making driving impossible, do not force the unit to move. Instead,
use normal or hot water to melt the frozen parts.
Please wait until the melting is complete before driving. (If you move the unit by force, resulting in an
accident, please be aware that the operator will be held responsible).
●
Following the information in the “Crawler tension adjustment” section, loosen the crawler tension
bolts.
●
Inspect each part and make any necessary adjustment.
●
Clean each part with a cloth soaked in oil. Oil all moving parts. Then store the unit in place with low
humidity.
●
Put planks or something similar under the crawler.
●
Put the deadmanʼs control clutch lever in the OFF position.
●
Concerning the engine
Put several drops of engine oil into the opening where the ignition plug will be installed, turn the
crank axle several times and install the ignition plug. Stop the crank axle with the pistons in the com-
pression position.
If gasoline is left in the carburetor for a long time, it will deteriorate and, as a result, the engine will
not start properly and will also develop irregular turning. Accordingly, before long-term storage, ex-
tract the fuel in the carburetor and the fuel tank. Also, avoid using gasoline that has been stored for a
long time or that has been in a plastic tank.
IBT500 REIMPAGINATO.indd 32 30/06/14 11.00