ikan IDX803 - Manual (Page 5)

IKAN
IDX-803 [EUM-A]
4
Chapter 2 IDX-803 Operation
2-1 SCENE Setting
STEP-1：Press【SC / CH】to select the control channel
LED：OFF  in CH Mode
LED：ON
 in SC Mode
STEP-2：Move【MASTER-VR】to the top
STEP-3：Move【VR-1 … VR-8】to dimming
STEP-4：press
【PROG】+【1…8】to confirm and save the selection
2-2 SCENE Recall
Refer to 2-1 to set the dimming value of SC-1…SC-8, use the following function
to recall the scene
A：0%…100% VR Control
STEP-1：Press【SC / CH】key to select【SC】 mode.(LED”ON”)
STEP-2：Press【VR-1…VR-8】
EX: to recall SC-2, adjust the【VR-2】, to recall scene 2 by dimming.
B : FLASH
STEP-1：Press【SC / CH】 to select【SC】mode. (LED”ON”)
STEP-2：Press【1…8】
EX: to recall SCENE 2, press【2】,and scene 2 switch to 100% full, and release the
1.) When MASTER-VR in 100%, and the VR-1…VR-8 in 50% of dimming value,
the SCENE total output channel dimming value will be 50%.
2.) When MASTER-VR in 50%, and the VR-1…VR-8 in 50% of dimming value,
the SCENE total output channel dimming value will be 25%.
Select 【CH】 mode, and move the fader to set the dimming value
Press【PROG】+【1~8】 to save control scene.