ikan PT3100 - Manual (Page 12)

INTRODUCTION
NVIDIA (see figure1)
When using your ikan teleprompter, you should set up you computer to be in “Clone
Mode” or “Mirror Mode”. We do this so the talent can see the exact same thing the
teleprompter operator is viewing. In this guide we will go over some of the most common
ways of achieving this. Before you start you should make sure you have the last drivers
for your video card. You should visit the manufactures website the get these. We will go
over the Nvidia , ATI, and Intel way of achieving this as they are what most computers
are equipped with nvidia (figure 1)
1) Fist thing to do is make sure that the monitor of your ikan teleprompter is plugged in
powered on and connected to the VGA port of your computer. (It’s the blue 15 pin
connector on the back of your computer)
2) The easiest way to set up your computer if you are using a laptop is to use the hot keys.
Most laptops have a set of keys you press at the same time to toggle between display
modes. In this particular case the key combination is FN and the F4 key.
You will press these keys until you get the same exact image on your ikan teleprompter
that you have on your laptop. The mode we are looking for is “Clone Mode”. Every
laptop manufacturer seems to have a different key combination so you should check
your user’s manual.
ATI (see figure2)
3) If the above step did not work or you are using a desktop computer then we can do it
the longer method. (Nvidia)
a. Right-Click on your desktop
b. Choose properties
c. Click on the Settings tab
d. Change the resolution of your monitor to 800x600 or 1024x768 and press the
apply button.
e. Now press the advanced button
f. Click on the tab labeled with the word GeForce or the Nvidia logo. (this may look
different depending on your graphics card model.)
g. Click on “Nview Display Settings” on the left side.
h. On the right side choose Clone from the Nview Display Mode drop down box.
i. Click on the apply button.
j. You should be in clone mode now. Close all open windows.
k. You are now ready to start Prompter Pro V2.
4) If step number 2 did not work or you are using a desktop computer then we can do
it the longer method. (ATI)
a. Right-Click on your desktop
b. Choose properties
c. Click on the Settings tab
d. Change the resolution of your monitor to 800x600 or 1024x768 and press the
apply button.
e. Now press the advanced button
f. Click on the Tab labeled with an ATI logo and the word “Displays”
g. Press the red button to the left of the word monitor. This will “turn on” your
secondary monitor (which is the ikan Teleprompter monitor)
h. Press the small blue button with two squares overlapping each other. This is the
“Clone Mode” button.
i. Now Press the apply button.
j. Your are now ready to start Prompter Pro V.2.
Q
UICK
S
TART
G
UIDE / PrompterPro V.2