Assembly instruction, Pt4000 – ikan PT4000 User Manual

Page 4

Advertising

ASSEMBLY INSTRUCTION

Attach another L-Bracket (Part-J) to the assembled parts. Make sure to arrange the long section of Part J as shown in the

illustration, otherwise there will not be adequate room to place the monitor. You will use 4 x Long Phillips head screws

(Part-G) and 2 x T-plates (Part-C) to attach it. Then, you will use 4 x Long Phillips head screws (Part-G) and 2 x T-plates

(Part-C) to attach the 15” T-slot (Part-O). Make sure to evenly tighten all screws in the assembly.

PT4000

20” TELEPROMPTER

Part-O

Part-G

Part-C

Part-J

ikancorp.com

Attach your tripod skid plate to Part-N.

For those who use a tripod that is rear loading (ie: your tripod skid plate slides into the tripod head from the rear), we have provided an

optional piece , Part-N, will allow for more convenient attaching and detaching of the PT4000 Teleprompter on your tripod.

> Loosen the screws and slide out the Metal Bracket

through the channels

> Install 2 x Part-A & Part-E or 2 x Part-B & Part-F

> Slide in the Metal Bracket through the single channel

of the bottom of the Part-P

> Attach your tripod skid plate to the remaining Part-N (8” T-Slot)

and secure them on your tripod head

> Attach the assembled teleprompter to your tripod

your

tripod

Part-N (Metal Bracket)

Part-N (8” T-Slot)

ikancorp.com

Important Note: Your tripod or pedestal should be a heavy-duty

grade. The PT4000 is a heavy studio teleprompter and many

tripods may not be able to hold the weight of it. Be sure that your

tripod and head can handle it.

3 of 10

Advertising

This manual is related to the following products:

Popular Brands

Popular manuals