ikan PDL - Manual (Page 5)

Battery Level and Corresponding LED Display
Important Notes
Status
Normal Operation
Charging
LED
White
Green
Yellow
Red
Purple
Capacity
75%-100%
50%-75%
25%-50%
Below 25%
Currently Charging
Button &
Interface
ON/OFF
Nerve
Motor
9v-20v
Operation Instruction
Press and hold for two seconds; do not release until blue light goes on.
Press and hold for two seconds; do not release until red light appears.
Press and hold for three seconds; do not release until lens rotates.
Five continuous short presses.
Seven continuous short presses to switch modes.
Function
Start-Up
Shutdown
Primary Lens Calibration
To Change Motor
Direction
Slow Ramp/Fast Ramp
Secondary Lens
Calibration (Point AB)
Return to Primary Lens
Calibration
1. Allow the product to charge fully before use.
2. Carefully clamp the lens with the motor cog-wheel.
3. If the LED is red it indicates the battery is low; recharge immediately.
4. The product contains a lithium-ion battery. DO NOT attempt to dismantle the shell;
doing so could result in damage to the cell or other dangers.
Press button twice; first a short press, then a long press.
Set Point AB by toggling the hand wheel at the same time;
do not release until it is finished.
Two continuous short presses to revoke the set stroke.
Setup
Revoke
Short press after re-start. Remote Live will automatically restore
previously saved calibration
Connection interface for 4-Pin LEMO Power Cable.
Connection for Motor Drive Cable (10-Pin LEMO)
* 4-6 Hours for full charge