ILS ILS14A - Manual (Page 13)

11
Motorized screen and elevation control.
Operating relays with 220 V power or without power
Motorized screen and elevation control (220V)
1) AMC - control the screen by 600 touch controller
2) Push the Down button to lower the screen
3) Pusg the Stop button to stop lowering or raising the screen
4) Push the Up button to raise the screen
*Note, The controller is set up to control the projection screen and projector elevator by the
relays for this function, switching the 220V that is fed to the controller on the right top socket.
If you intend to control these functions by simply opening and closing a circuit that is not powered
by the relays itself, do not attach the 220V in the socket at the back of the controller.
Instead wire as below, otherwise systems attached to these Phoenix plugs may get damaged.
Internal layout for screen and elevation (220V)
The screen and elevation each have 2 relays.