ilve Cleaning Guide - Manual (Page 9)

CLEANING
TROUBLE SHOOTING GUIDE
PROBLEM ANSWER
OVENS
How do I change the door seals?
Please note: the replacement of oven door seals does not require a service technician. Door seals
are easily replaced, please contact your ILVE state office, who will arrange for a replacement to be
sent. If out of warranty please contact the ILVE spare parts department on
1300 MY ILVE (694 583) or [email protected]
My oven will not turn on
but the clock is illuminated
(digital type clock)
This problem can occur after a power interruption or when the power is first turned on to the
appliance. The display will show an “A” and the clock needs to be reset. This can be done by
pressing both pot buttons (
) simultaneously. The time can be adjusted by pressing the +/-
buttons. For full instructions refer to the operating manual supplied with the appliance or available
on line at www.ilve.com.au
Oven will not turn on
(Analogue type clock)
For the oven to work manually, the hand symbol must be displayed in the little window on clock.
For full instructions refer to the operating manual supplied with the appliance or available on line
at www.ilve.com.au
My oven smokes when turned on
This is a natural occurrence and is caused by the self-clean burning off process. A good tip: leave
the oven on at a high temperature for 10 minutes after removing cooked food. This will burn off
any splatter and prevent the oil from going cold. It will then start to burn off when oven is next
turned on. Please note: all ovens will occasionally require to be dismantled and cleaned internally,
even if self-clean liners are fitted. Do not use oven cleaner on self-clean liners. For full instructions
refer to the operating manual supplied with the appliance or available on line at www.ilve.com.au
My oven gets too hot externally
Check that the correct ventilation has been allowed. See illustrations of ventilation requirements
in the installation book. Please note that being an oven, the external panels will warm up after the
oven has been on for over an hour, at high temperatures. This is normal heat transfer; the panels
can heat up to around 60ºC.
I am unable to remove the light
cover to replace the globe
Cover the glass with e.g. an old tea towel and use multi-grip pliers to lightly grip the cover and
undo it turning anti-clockwise.
The oven light is not working All current model ovens require the function knob to be pushed in/out to turn light on or off.
9 ILVE Freestanding Operating Manual