Insinger SW-48-RI - Manual (Page 16)

16
DOC SW‐48‐RI 2.2010 www.insingermachine.com
suds detergent is necessary and local water conditions should be considered when selecting the
concentration of the detergent. An automatic soap dispenser should be installed at the job site by the
chemical supplier. There should be a visible or audible means of determining detergent delivery. If
they have any questions concerning the installation of their dispenser to the INSINGER pan washer,
they can call the factory for advice.
8. The rack of pans can now be placed in the machine. The rack should be centered in the machine to
subject the pans to the full force of the spray arms.
WARNING : Loose items and glassware should not be put in the washer. The high pressure wash
cycle will damage them and potentially the machine.
Bowls or buckets can be washed by placing them upside down on the main support rack with the hold
down rack installed above them in the lowest possible position.
The utensil basket is to be used to contain smaller items such as paddles, whisks, scrapers, etc. The
utensil basket can be placed on top of the hold down rack and washed along with a load of pans or
buckets. The utensil basket may need to be held in place by the hold down rack to prevent it from
moving in the machine.
CAUTION : When loading the machine make sure that nothing will obstruct the path of the wash
arms. This will avoid damage to the machine and to the items being washed.
When loading bowls, pans, or buckets into the machine make sure they are loaded in a manner that will
allow the wash water to drain out of them.
9. The machine cycle is completely automatic with adjustable wash, rest, and rinse timers. The timers are
located in the control panel and are factory set to the following recommended values:
Wash Light 3 min
Medium 5 min
Heavy 7 min
Rest 20 sec
Rinse 60 sec
Fan (optional) 30 sec
Select the length of wash (Light/Medium/High) with the 3 position selector on the button panel and
push the green start button to initiate the wash cycle. The red indicator light will come on. At the end
of the wash cycle the red light will stay on and the 20 sec rest will begin. The rest period allows the
wash water and suds to drain from the pans. After the rest cycle, the rinse cycle begins. During the
rinse cycle, the clear indicator light will come on. If the machine is equipped with a fan timer (see page
11 for a description of the fan options) the fan will start after the rinse is finished. After the rinse or fan
cycle is finished the red and clear lights will go off. The cycle is now complete. The amber power light
will stay on as long as the power switch is in the "ON" position and there is enough water in the
machine.
10. Throughout the day as the machine is being used, the scrap tray screens (see page 37 for location of
screens) should be periodically removed from the machine, dumped out, washed out in the sink and
replaced in the machine.