InSinkErator Hot1 - Manual (Page 3)

Spout
Spout Holder
Maximum
Countertop
Thickness
for Mounting
3 Wire
Power Cord
30" Long
(76cm)
Slotted
Set Screw
(Opposite Side)
Valve
Lever
Rubber
Gasket
Mounting
Nut
Wing
Nut
¼" Copper Tube
16" Long
(40.6cm)
Cold Water Line
Width of
Unit 5¼"
(13.3cm)
6"
(15.2cm)
2"
(5.1cm)
3"
(7.6cm)
11¾"
(28.9cm)
4"
(10.2cm)
2½"
(6.4cm)
8
2¼ "
(6.5cm)
9 16
The wall outlet for your dispenser must have power supplied to it continuously
and must be fused. It should not be controlled by the same wall switch
that operates your disposer.
PREPARATION
START HERE
■ ■
Identify location for the dispenser.
■ ■ Check to make sure there is proper
clearance for dispenser handle to be
fully opened.
■ ■
Check to make sure counter is not
too thick.
■ ■
Make sure there is a grounded
electrical outlet under the sink.
■ ■ Turn off water supply.
■ ■
If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
■ ■
Using adjustable wrench, remove
nut connecting sprayer washer
flange in sprayer hole.
■ ■
Plug hose opening with either a 1/8"
plug or a 1/4" cap (not supplied).
1
A
B
Consult a professional before drilling into
a surface other than stainless steel.
C
What if you don’t have a sprayer hole or
don’t want to use it?
■ ■
Many homeowners replace the soap
dispenser in their sink with an instant
hot water dispenser.
■ ■ If drilling a hole into a stainless steel
sink or counter top, you can cut a
mounting hole for the dispenser with a
hole saw for stainless steel, or you can
use a hole punch.
Required Hole Diameter
1 3 ⁄
8
"
Required minimum from
center of hole to wall
Maximum counter
thickness (depth)
3 3 ⁄
4
"
2"
DIMENSIONS
4 5
If you have to drill through sink or
countertop, you may need to rent or
purchase the appropriate tools.