Jetway Computer NF9Q - Manual (Page 39)

34
WatchDog Timer
Use this item to enable or disable WatchDog Timer Control. When set as
[Enabled], the following sub-items shall appear:
WatchDog Timer Value
User can set a value in the range of 4 to 255.
WatchDog Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select ‘AT or ATX Mode’ on MB jumper at first(ATX Mode &
AT Mode Select).
The optional settings are: [Enabled]; [Disabled].
Case Open Detect
This item controls detect case open function.
The optional settings are: Enabled]; [Disabled].
 PC Health Status
Press [Enter] to view hardware health status and set ‘Shutdown Temperature’.
Shutdown Temperature
Use this item to select system shutdown temperature.
The optional settings are: [Disabled]; [70 C/156 F]; [75 C/164 F]; [80 C/172 F]; [85
C/180 F]; [90 C/188 F].
 SmartFan Configuration
Press [Enter] to make settings for SmartFan Configuration:
FAN2 Type
The optional settings are: [3 pin]/ [4 pin].
CPUFAN / SYSFAN1/ FAN2 Smart Mode
When set as [Enabled], the following sub-items shall appear:
CPUFAN / SYSFAN1/ FAN2 Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN1/SYSFAN2 full speed temperature. Fan
will run at full speed when above this temperature.