Kleenmaid ICK60X - Manual (Page 7)

6
Installing your hob in complete safety
4mm minimum
air outlet full
width of cooktop
40mm minimum
Induction Hob Bench Top
50mm vent holes into
cabinet on both sides
cabinet on both sides
Vertical divider
Oven cavity must
be air tight at top
Bottom Shelf
under Bench O
v
en
Kick Board
Above an oven
4 cm mini
Ensure that the unit crossbar does not block the air
passage, make a bevel if necessary.
Above a cupboard or drawer unit
Gap
When installing induction hob above any oven the following ventilation requirements must be observed:
* Divider shelf separating the hob from the oven to be positioned at least 50mm below hob.
* Cooktop must be isolated from any oven cavity ie. under bench.
* A vertical division to be positioned between the divider shelf and the underside of the hob
approximately 300mm from the back of the cupboard.
* Ventilation holes must be drilled into side of adjoining cupboards to allow supply of fresh air to cooktop.
Incorrect installation may result in premature failure of cooktop and will void warranty.
WARNING: The installation instructions must be followed or warranty will be void.
Always ensure that the air vents beneath the hob are kept clear.
Your induction hob must always be adequately ventilated.
99629201_GB_A.qxd 27/05/03 08:42 Page 6