Kleenmaid RH30 - Manual (Page 6)

5
bipolar switch with a minimum contact opening of
no less than 3mm.
If the plug is not accessible once it has been
inserted in the socket, it will however be
necessary to fit an approved bipolar switch with
a minimum contact opening of no less than
3mm.
Appliance without plug
Fit an approved plug or an approved bipolar
switch with a minimum contact opening of not
less than 3mm.
The manufacturers are not liable for any
problems caused by the user’s failure to
observer the above instructions.
Systems available
Two systems are available:
Exhaust mode
Vapours are extracted outside through an
exhausting pipe that is affixed to the connection
ring above the hood.
Diameter of the exhausting pipe must be equal
to that of the connection ring.
In the horizontal runs the duct must be slightly
slanted (about 10°) and directed upwards to
vent the air easily from the room to the outside.
Attention!
If the hood is supplied with carbon filter,
then it must be removed.
Filter version
The air is filtered through a carbon filter (for its
installation see paragraph "Carbon filter") and
recirculated through the room via an exhausting
pipe that is affixed to the connection ring above
the hood. The exhaust pipe must run from the
hood up t
hrough the cupboards and dispersed
into the room from the top of the cupboards..
GB
According the cooker hood you own:
Lamp 40W max (E14) or Neon lamp 14W
max or PL lamp 11W max (model with 1 PL
lamp) or PL lamp 9W max (model with two
PL lamps)
4. Reclose the protective shield for the lamp.
Before calling for repair service because the
hood fails to light up, make sure the lamps are
well inserted.
Warning!
— The hood cannot be connected to flues of
other appliances that run on energy sources
other than electricity.
— When the hood is used at the same time as
other appliances that run on energy sources
other than electricity, provision must be
made for an adequate supply of air.
— No food must be cooked flambé underneath
the hood.
The use of an unprotected flame is
dangerous for the filters and could cause
fires.
Therefore, never use an open flame under
the hood. When frying foods, never leave
the pan alone because the cooking oil could
flare up.
— Please, keep to the provisions of official
directives regarding the question of fume
discharge.
— The manufacturers refuse to accept any
responsibility for damage to the hood or its
catching on fire because of failure to observe
the above instructions.
Installation
Do not tile, grout or silicone this appliance to the
wall. Surface mounting only.
These minimum distances between hobs and
grease filter must be observed:
Minimum 650 mm - electric gas or m ixed.
Electric connection
Before completing any connection, make sure
the house voltage corresponds with the voltage
indicated on the label affixed inside the hood
It is advisable to call a qualified technician to
make the electrical connection.
Appliance fitted with plug.
Connect it to a socket which conforms with
current regulations.
If you intend to connect it directly to the electric
mains, remove the plug and fit an approved
Replacement lamps are not covered by warranty.
*Please confirm these measurements with your
Local Building Authority.
Attention!
If the hood is not supplied with carbon filter,
then it must be ordered and mounted.
This version is used when there is no exhaust
duct for venting outdoors or when it is impossible
to install one.