Kleenmaid ETH-Power Head for VC350 - Manual (Page 5)

Use
1. Indicator light
On top of the power brush is a red/green indicator light. lf the
green light is on and the swivel neck is in the upright position,
then the power brush is ready for operation. By lowering the
swivel neck the brush is activated. Please ensure that the
vacuum cleaner is set to maximum power.
Green and red lights on together indicate security shut down
because of either overload or blockage.
2. Brush adjustment
On top of the power brush there is a rotary control to adjust
brush action. Brush action can be set from SOFT through to
HARD as appropriate.
Attention - safety advice for use:
- the machine has a rotating brush
- always take care that the brush does not pull in
rug edges, fringes, cables etc.
- Berber, woven and other delicate floorcoverings or
floors with delicate surfaces please clean with the
combination nozzle of your vacuum cleaner
- on uneven floors contact with the bottom plate is
possible. Use combination nozzle if damage may
occur
- lift the machine over obstacles
ATTENTION - switch off and unplug machine at the
mains outlet and from the vacuum before all service
work and before removing any part.
Attention - safety advice for
connection :
- connect only to outlets according
to data shown on labels
- mains voltage for both machines
must be the same
- the vacuum cleaner must be
switched on and provide air-flow
through the power brush
- the cable must be fixed along
the hose and be plugged into the
vacuum
Clearing a blockage (-unplug the vacuum cleaner at
the mains outlet)
lf the brush is not functioning correctly it may be blocked.
A red trap door is provided on the underside of the power
brush to aid blockage clearing.
To clear a blockage in the swivel neck push the obstruc-
tion down the neck with a stick or long screwdriver and
then remove it through the red trap door
Changing the brush roller (-unplug the vacuum cleaner at
the mains outlet)
To change either. the brush roller (19) or the edge-cleaning
brush (19a), push the button (20 or 20a), swivel the end caps
in the direction of the arrows and pull them off.
Turn the brush roller clockwise and the edge-cleaning brush
anti-clockwise when removing them from the appliance. Fit the
new brushes onto the drive shaft by turning them until they
click into position. Also to refit the end caps turn them until
they click into position. Make sure not to squeeze the bristles
of the brushes under the end caps.
Service - ( unplug the vacuum cleaner at the mains outlet)
The brush should be cleaned of fibres and hair regularly. After
a blockage or when the brush has pulled in something, clear
the brush and take all debris out of the brush area. Check the
swivel neck regularly for blockages. Do not open the machine.
green red